Spa Jet Pump Flow Demand
Calculator
Results
- Total flow demand (L/min)
- 90
- Total flow demand (L/h)
- 5,400
Pool and aquarium results
| Total flow demand (L/min) | 90 |
| Total flow demand (L/h) | 5,400 |
formula-map diagram
- Total flow demand (L/min)
- 90
- Total flow demand (L/h)
- 5,400
Pool and aquarium relationship
Formula
demand = jet count × flow rate per jet= 90
Note
This is a simplified model: it applies a standard geometric or physical formula to the numbers you entered. Volumes assume a regular shape and an even average depth, and the kidney shape uses the common 0.45 × (A + B) × L area approximation. Chemical doses convert a target change into a product mass using the strength or label dose you enter, because the amount of active ingredient varies from product to product; they ignore pH, temperature, buffering, sunlight, bather load and existing chemical interactions. Heating uses Q = m × c × ΔT with c = 4186 J/kg·K and ignores heat losses to air, ground and evaporation; evaporation and cover figures use the rate you enter, not local weather. Aquarium stocking by surface area is a rule of thumb, not a biological limit. Always follow the product label and test the water before and after dosing, and consult a pool or aquarium professional for anything you are unsure about.
Example: with the default inputs, calculator.pool.total_flow_demand_lpm is 90.
More in Pool and aquarium
See all →Frequently asked questions
How is the spa pump flow demand calculated?+
The calculator multiplies the number of jets by the flow rate per jet (L/min). With the defaults of 6 jets at 15 L/min each, the demand is 90 L/min.
Does it also show the result in litres per hour?+
Yes. It multiplies the L/min total by 60, so 90 L/min becomes 5,400 L/h.
Where do I find the flow rate per jet?+
You enter it. Use the rated flow of your jets from the manufacturer's information; the calculator does not look it up.
Does this tell me which pump to buy?+
No. It only gives the total flow the jets together would demand. Pump selection also depends on other factors that are not part of this calculation, so check with the manufacturer.
Does it consider pipe losses or jets that differ from each other?+
No. It assumes every jet has the same flow rate and adds nothing for pipe or fitting losses.