Spa Chemical Dose Scaled
Calculator

Inputs

Increase needed (ppm)
4

Results

Increase needed (ppm)
4
Water volume (m³)
1.5
Product to add (g)
90
Product to add (kg)
0.09

Pool and aquarium results

Increase needed (ppm)4
Water volume (m³)1.5
Product to add (g)90
Product to add (kg)0.09

formula-map diagram

Increase needed (ppm)
4
Water volume (m³)
1.5
Product to add (g)
90
Product to add (kg)
0.09

Pool and aquarium relationship

Formula

spa dose = (target − current) × pool label dose × volume(m³) × spa factor

= 4

Note

This is a simplified model: it applies a standard geometric or physical formula to the numbers you entered. Volumes assume a regular shape and an even average depth, and the kidney shape uses the common 0.45 × (A + B) × L area approximation. Chemical doses convert a target change into a product mass using the strength or label dose you enter, because the amount of active ingredient varies from product to product; they ignore pH, temperature, buffering, sunlight, bather load and existing chemical interactions. Heating uses Q = m × c × ΔT with c = 4186 J/kg·K and ignores heat losses to air, ground and evaporation; evaporation and cover figures use the rate you enter, not local weather. Aquarium stocking by surface area is a rule of thumb, not a biological limit. Always follow the product label and test the water before and after dosing, and consult a pool or aquarium professional for anything you are unsure about.

Example: with the default inputs, calculator.pool.ppm_increase is 4.

More in Pool and aquarium

See all →

Frequently asked questions

How is the spa chemical dose calculated?+

The calculator uses: dose = (target − current ppm) × pool label dose × volume in m³ × spa factor. The result is in grams and kilograms of product.

What is the pool product dose I must enter?+

It is the grams of product per m³ needed to raise the level by 1 ppm, as given on your product's label. The default of 10 g is only a placeholder.

What does the spa concentration factor do?+

It is a multiplier applied to the pool-based dose; the default is 1.5. Set it to 1 for no scaling, or follow your product's instructions.

What happens if the target is below the current level?+

The ppm change becomes negative, so the calculated dose is negative. In practice this means no product is needed.

Can I rely on this for safe water treatment?+

It is an estimate only. Always follow the product label and your spa manufacturer's instructions, and test the water before and after dosing.