Pool Solar Cover Night Loss Reduction
Calculator

Inputs

Uncovered nighttime heat loss (W)
4,000

Results

Uncovered nighttime heat loss (W)
4,000
Nighttime heat loss avoided (W)
2,400
Remaining nighttime heat loss (W)
1,600

Pool and aquarium results

Uncovered nighttime heat loss (W)4,000
Nighttime heat loss avoided (W)2,400
Remaining nighttime heat loss (W)1,600

formula-map diagram

Uncovered nighttime heat loss (W)
4,000
Nighttime heat loss avoided (W)
2,400
Remaining nighttime heat loss (W)
1,600

Pool and aquarium relationship

Formula

avoided loss = area × base loss(W/m²) × (reduction ÷ 100)

= 4000

Note

This is a simplified model: it applies a standard geometric or physical formula to the numbers you entered. Volumes assume a regular shape and an even average depth, and the kidney shape uses the common 0.45 × (A + B) × L area approximation. Chemical doses convert a target change into a product mass using the strength or label dose you enter, because the amount of active ingredient varies from product to product; they ignore pH, temperature, buffering, sunlight, bather load and existing chemical interactions. Heating uses Q = m × c × ΔT with c = 4186 J/kg·K and ignores heat losses to air, ground and evaporation; evaporation and cover figures use the rate you enter, not local weather. Aquarium stocking by surface area is a rule of thumb, not a biological limit. Always follow the product label and test the water before and after dosing, and consult a pool or aquarium professional for anything you are unsure about.

Example: with the default inputs, calculator.pool.uncovered_loss_w is 4000.

More in Pool and aquarium

See all →

Frequently asked questions

What does this calculator compute?+

The night-time heat loss avoided by a pool cover. It multiplies the water surface area by the uncovered loss in W/m², then applies your percentage reduction.

Which inputs do I need?+

The water surface area in m², the uncovered night-time heat loss in W/m², and the heat-loss reduction from the cover in percent. Both the loss and the reduction are values you supply.

What results do I get?+

Three values in watts: the uncovered loss, the heat loss avoided by the cover, and the remaining loss with the cover on.

Is the 60% reduction a measured value for my cover?+

No. It is only the default entered in the field. Real reduction depends on the cover, so replace it with a figure that fits your situation.

Does it give energy or cost savings?+

No, it returns power in watts only, not energy over the night or a cost. It is a rough estimate that depends on the figures you enter.