Wood Panel Square Check
Calculator
Results
- Theoretical diagonal (mm)
- 721.110255
- Diagonal difference (mm)
- 0
- Average measured diagonal (mm)
- 721.1
- Deviation from theoretical (mm)
- -0.010255
Results
| Theoretical diagonal (mm) | 721.110255 |
| Diagonal difference (mm) | 0 |
| Average measured diagonal (mm) | 721.1 |
| Deviation from theoretical (mm) | -0.010255 |
formula-map diagram
- Theoretical diagonal (mm)
- 721.110255
- Diagonal difference (mm)
- 0
- Average measured diagonal (mm)
- 721.1
- Deviation from theoretical (mm)
- -0.010255
Formula map
Formula
Square when diagonal A = diagonal B = √(W² + H²)= 721.1102550928
Note
This result is a simplified model; verify against your shop's own tolerances and material data before cutting.
Example: with the default inputs, calculator.woodwork.theoretical_diagonal_mm is 721.1102550927978.
More in Woodworking and metalwork
See all →Frequently asked questions
How do I check if a panel is square using diagonals?+
Measure both diagonals of the panel. If they are equal, the panel is square. The calculator shows the difference between your two measurements.
What is the theoretical diagonal?+
It is √(width² + height²), the diagonal a perfect rectangle of the width and height you entered would have. The calculator compares your average measurement to it.
What does the deviation from theoretical mean?+
It is the average of your two diagonals minus the theoretical diagonal. A positive value means the measured diagonals are longer than expected, a negative one shorter.
Does a difference of zero guarantee a perfect panel?+
Equal diagonals prove a rectangle only if opposite sides are also equal. Use the deviation from the theoretical diagonal to check the dimensions as well.
What tolerance counts as square?+
The calculator does not set one. It reports the differences in millimetres, and you decide what is acceptable for your project.