Miter Joint Length Loss
Calculator

Inputs

Extra length per end (mm)
44.999999

Results

Extra length per end (mm)
44.999999
Extra length, both ends (mm)
89.999999
Outside-to-inside offset (mm)
44.999999

Results

Extra length per end (mm)44.999999
Extra length, both ends (mm)89.999999
Outside-to-inside offset (mm)44.999999

formula-map diagram

Extra length per end (mm)
44.999999
Extra length, both ends (mm)
89.999999
Outside-to-inside offset (mm)
44.999999

Formula map

Formula

Extra length per mitred end = frame width × tan(mitre angle)

= 45

Note

This result is a simplified model; verify against your shop's own tolerances and material data before cutting.

Example: with the default inputs, calculator.woodwork.extra_length_per_end_mm is 44.99999999999999.

More in Woodworking and metalwork

See all →

Frequently asked questions

How is the extra length for a mitred end calculated?+

The calculator multiplies the frame member width by the tangent of the mitre angle: extra = width × tan(angle). It shows this per end and for both ends together.

What does the mitre angle mean in this calculator?+

It is the cut angle measured from square, in degrees. A 45° cut, the default, gives tan(45°) = 1, so the extra length per end equals the member width.

What is the extra length used for?+

It is the additional length that each mitred end adds compared with a square-cut piece of the same width. Both ends are counted in the second result, which is twice the per-end value.

Why is there an outside-to-inside offset result?+

It reports the same value as the extra length per end, which is the width × tan(angle) distance along the member between the outside and inside corners of the mitre.

Can I use any angle?+

Any angle above zero is accepted, but the tangent grows quickly as the angle approaches 90°, so large angles give very large lengths. Check the setting of your saw and test on offcuts before cutting final stock.