Climb Gradient Percent
Calculator

Inputs

Climb gradient (%)
10

Results

Climb gradient (%)
10
Climb gradient (ft per NM)
607.611548

Aviation and marine results

Climb gradient (%)10
Climb gradient (ft per NM)607.611548

formula-map diagram

Climb gradient (%)
10
Climb gradient (ft per NM)
607.611548

Aviation and marine relationship

Formula

Gradient (%) = altitude change ÷ horizontal distance × 100

= 10

Note

This is a simplified model: it applies a standard navigation, performance or seamanship formula to the numbers you entered. True airspeed and density altitude use the ISA troposphere model for dry air and ignore humidity, compressibility and instrument or position error, so they are not a substitute for your aircraft's flight manual or an air data computer. Wind, climb, descent and fuel figures assume a steady wind and a constant speed and fuel flow for the whole leg; they ignore manoeuvring, holding, taxi and start-up fuel, terrain, turbulence and air traffic control routing. Takeoff distance scales an entered sea level figure by a rule-of-thumb percentage per 1000 ft of density altitude and is not a certified performance chart. Weight and balance results depend entirely on the arms and weights you enter and must be checked against the approved loading envelope. Hull speed is the classic 1.34 × √LWL displacement estimate, boat fuel burn is a horsepower-based approximation, anchor scope is a rule of thumb, and the rule of twelfths is a linear approximation of a sinusoidal tide that does not hold in all locations. Always use official charts, tide tables, the aircraft or vessel manuals and current weather, and treat these numbers as planning estimates only.

Example: with the default inputs, calculator.aviation.climb_gradient_percent is 10.

More in Aviation and marine

See all →

Frequently asked questions

How do I calculate a climb gradient in percent?+

Divide the altitude change by the horizontal distance and multiply by 100. Enter both in feet.

What is the ft per NM result?+

It is the same gradient expressed as feet gained per nautical mile, using 1 NM = 6,076.11548556556 ft.

Do both inputs need the same unit?+

Yes. Both the altitude change and the horizontal distance are in feet, so the ratio is unitless before it becomes a percentage.

Is the gradient measured over the ground or through the air?+

This calculator only divides the two numbers you give it. It does not apply any wind correction or convert between ground and air distance.

Can I use it to check obstacle clearance or procedures?+

It gives a simple geometric estimate. For real procedures and obstacle clearance, use official published data and your flight manual.